Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to change 1130AP's hostname, not via CLI or web interface of aironet 1130AP, but via the controller's web interface ?Are there possibility to give any bad impact on the Aironet if I do this ?best regards
How can I enter into "interface configuration" on Aironet 1130AG, AIR-LAP1042N?When I put following commands in enableconf tinterface Dot11Radio1but, it fails and I cannot enter into "interface configuration".How can I do this ?The reason why I ente...
Hi experts.I configured vpn connection between cisco1841 and ASA.I want to keep ipsec permanently even if no data packets,I put commands on 1841 like following.'crypto isakmp keepalive 30 periodic"However vpn is disconnected after a while if no data...
Hi, experts.I need to set up Lan-to-Lan vpn and remote-vpn for Cisco remote client.I configured Two crypt map for VPN on Cisco1841( c1841-advipservicesk9-mz.124-15.T6.bin).One is for Lan-to-Lan VPN, The other is Remote access VPN (for Cisco remote cl...
Thank you for your information.According to the URL link you sent ,this means the boot loader error.so, How can I recover boot loader error of AIR-AP1131AG-E-K9 ?best regards
Thank you for your information.Is it possible to disable cdp by using " no cdp enable " after entering into the config mode on 1130AG via CLI ?like ,interface Dot11Radio0no cdp enablebest regards
Thank you for your reply.I want to make it clear,Do you mean I need to put some commands on both sides equipments like following?for Phase 1(config-isakmp)#lifetime 86400for Phase 2set security-association lifetime seconds 3600
