Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I have an IP Phone on Inside, the IP Call Manager is located on the dmz, all the the ports are open between this two devices (permit IP), moreover, I can ping one device to another. But the Ip phone is unable to make a call, no dial tone. ...
Hi all, We have an AS5850 registered with a softswitch using MGCP, but the AS5850 is sending this message:Dec 28 20:49:48.137: send_mgcp_msg, MGCP Packet sent to 200.75.xx.xx:2727 --->Dec 28 20:49:48.137: 500 121454 Endpt UnknownHere is the AS5850 co...
Hello Patrick, Thanks for the information. The first part that you mention is covered here:fixup protocol dns maximum-length 512fixup protocol ftp 21fixup protocol h323 h225 1720fixup protocol h323 ras 1718-1719fixup protocol http 80fixup protocol rs...
Hi, Thanks for your help, but is not clear for me, in the AS5850 where can I configure the name? how do I know what name is using now?Thanks in advance..mauricio
I implemented a WAN load balancing solution using Distributed and Local DIrector, It works very good across 6 countries in America and Spain with central location in Miami. Distributed Director uses the best time response or avaliability from the cl...
After you read all the info about subnetting you can use a very useful software like IP Subnet Calculator. To calculate your subnets and masks.www.wildpackets.com
Try looking this paper, it shows how to Receive Full Internet Routing Table, Receive Directly-Connected Routes and Receive Default Routes Only from your providers.http://www.cisco.com/warp/public/459/27.htmlMauricio
