Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Follow up to: https://supportforums.cisco.com/thread/2137000Cisco UCS 2x0 system with a LSI 1064-based controller mezzanine cardI have a RAID1 setup with drive #1 and drive #2. I shut down the server, pulled out drive #2, and inserted a brand new (n...
I'm wondering if I'm missing some existing documentation?Is there not just a single DVD I can load into the server and have it run through all of the firmware updates?Does Cisco provide this?I've tried to look through the site, and was hoping I didn'...
Ciscu UCS C200 M2 with RHEL 5.7 64-bitI have a situation where I'm going to have to break the RAID-1 (hardware) setup that I have every quarter. I'm going to have to pull out one of the drives, ship it off site, and replace it with another, and have...
We have a problem with our Gigabit Ethernet ports on the supervisor engines of our older CAT 5xxx switches.How would I go about discovering all the supervisor engines in my network that have the "up" GigE ports on them?I have the list of devices. Ca...
So that's the thing... The disk isn't failed. This is the backup strategy in place for some "very secure servers". The client doesn't even want their corporate backup server in this case.The backup strategy is to cycle through the drives every qua...
Several years ago when I was working on another vendor's hardware, they had utilities for all supported OS to be able to query/interact with the hardware. I can't remember exactly, but I'm wondering if one utility could at least query the status of ...
