Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I am trying an ASAv deployment with IPv6. Topology has ASAv in routed mode and IPv6 VMs behind both inside and outside interfaces.Ping from outside VM to inside VM is successful and observe that the ipv6 neighbor table is populated rightly.Eve...
Hi Valentino,VMK for L3 communication on ESXi in DHCP should work without any problems. You will get "ERSPAN-VEM : L3Control/ERSPAN" messages on VSM when a vmknic with "l3 capability" is created,removed or ip addr change.Can you please let us know if...
Hi,Yes you are right. Its only for how the VSM and VEM will communicate.Addition to svs mode, the control vlan and packet vlan config in svs-domain should be removed using the commands "no control vlan" and "no packet vlan".svs-domain no control ...
Hi Gavin,VSM and VEMs can be in the same subnet for L3 mode of connectivity.The problem I see in your setup is usage of "capability l3control" port-profile on VSM's mgmt interface.Since VSM's mgmt interface is also needed to be in the same subnet as ...
