Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,I need to limit a port to 3mbps each way on my 3750G-24T switch. The switch is running 12.2(35)SE2 software. The port user is Internet traffic only.The switch does not have the rate-limit or traffic shaping commands that I have seen on my route...
I have a test lab setup with a DHCP server (RHEL3WS Linux), a PIX501 firewall (6.3.4), a 2821 router (12.3.?), and a Windows XP host.The Linux server is running DHCP and I have the PIX configured to work as a DHCP relay from the outside interface to ...
Hello,I have a 2821 router. Currently, I have two bonded T-1 circuits to the Internet.I would like to add a DSL circuit to augment the T1s. I would also like to load balance across all of the circuits. Currently, IOS performs inherent load balanci...
Hello,I am having a problem getting two servers to communicate across security zones.Here is the basic configuration:PIX515 (PIX OS 6.3(4) & PDM 3.0(3)):inside: 10.200.10.1/24dmz: 172.16.1.1/24outside: 1.1.1.1/32I have database server on the inside a...
Hello,I have a PIX515 running 6.3(4) and PDM 3.0(2).I recently installed the latest Java software on a Windows 2000 machine. Despite checking the PDM configuration multiple times, I get an "Access denied" error when trying to access the PDM.I also h...
PPTP is an older protocol. Its been a good 5-7 years since I've used it. Cisco still supports it but they would probably encourage you to use IPSec if possible.IPSec is the current standard.You may want to take a look at the following modules even ...
I thought you were doing IPSec tunnels. With PPTP, I am not sure how to do that.I don't know how feasible it would be to consider IPSec tunnels - you would have to distribute the VPN client (according to the license agreement) - but the VPN Wizard m...
I guess I didn't ask about which code version you are running - but it probably doesn't matter much.Yes, the PDM software is for PIX OS 6.0 - 6.3 (roughly - I was a CLI user until fairly recently)The ASDM software is for PIX/ASA OS 7.0 or greater.PIX...
John,You have to configure split-tunneling for client Internet access.In the group policy for the remote access group, it resembles the following: split-tunnel-policy tunnelspecified split-tunnel-network-list value mygroup_splitTunnelAclI normally co...
