Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am upgrading from Websense 4.X to Websense 5.5.I am also Converting branch offices from Novell to Microsft AD 2003. The old websense server is configured to integrate with the novell sites to filter web traffic and I want to set the new websense s...
Hello, I have a 2950 and have tried in vain to confure a single port to try out dot1x authentication on it. When I set dot1x port control to auto, and check the status of the port using "Show dot1x all" command it keeps saying the port status is "n/a...
Hello,I have a 2950 and have tried in vain to confure a single port to try out dot1x authentication on it.When I set dot1x port control to auto, and check the status of the port using "Show dot1x all" command it keeps saying the port status is "n/a"....
Thanks for the response, yes that sounds like a really good idea.I wish I would have heard it last week, as I have already setup my new websense server stand alone and have implemented it.It seems to work, I think after my original Websense server is...
Thanks for the response.That actually suprises me in that I have for the most part found Cisco equipment to be so modular and configurable that almost anything is possible in the manipulation of IP packets.I have spoken with Websense, and they sugges...
Thanks Andy,I will do some more reading on the Vendor options. From what I can see from Debug on the switch and in the MS server event logs, communication is attempted but fails to negotiate.At least now I know the general direction to look in to fi...
THANK YOU!The "dot1x system-auth-control" command worked!From all of the documentation I read this command was not listed.Now all I have to do is everything else.Do you know if you can use a Microsoft IAS server as a Radius server for Cisco Switches ...
