Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have 2 Firepower 41xx managed by a vFMC.All time and timezone settings are configured fine on FCM, FMC and FTDs, but vFMC dashboard on Analysis-Connections-Events I see immediately the log session, but with 5 minutes before of time logging. ...
Hi Guys, I have a MultiPod (with IPN connection) configuration version 4.1 and I wuold like to configure QoS (or something else) in this way: Scenario is 1 server in Pod1 and another 1 server in Pod2.Both server are in the same EPG. Servers interfa...
Hi all, in a normal MultiPod configuration as picture MultiPoD.png, I'd like understand better how the connections between IPN Pod1 and IPN Pod2 works in terms of traffic flow and bandwidth usage. Assuming to have a 2x10 Gbps dark fiber between I...
Hi, leaf 93108 won't boot as leaf (ACI mode).It remains in loader> mode.If i try to boot image from USB, It fails again. This is the error messages:loader > rebootCISCO SWITCH Ver7.65Device detected on 0:1:2 after 0 msecsDevice detected on 0:1:1 a...
Hi,
I need to ask someone have the behavior I describe below:
I'm stretching Layer 2 with 2 EPGs and when I put both EPG into the same Bridge Domain, I see a ping packet loss to their default gateway.
Default gateway is a device out of Cisco AC...
Hi, what does it means "In case of FW you need PBR on both sides"?Sides=tenants? Or simply do you means both sides are the two arms of firewall?? Thanks a lot if you reply
