Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm using one of my SG350 switches as a WAN switch where 2 of the ISPs terminate in my switch in 2 SFP ports.I'm using this switch only as L2 where i am getting uplinks for the ISPs and giving down links to a pair of Juniper firewalls in HA mode.I on...
This switch acting pure Layer2 i do not see any issue here in the config ( may be try reset to factory keep Layer 2 only and test it).I did a factory reset as well and upgraded the firmware to latest image. the ping results you posted every 20ping 1...
I used the below link to configure the server,https://bchavez.bitarmory.com/how-to-setup-a-windows-2008-r2-sntp-ntp-server/# I think it contains almost all the main steps to enable NTP. that is mentioned in the link that you posted. Right now, my edg...
Yes. I can do that with proper approvals but I was curious to know why itwasn't working. The current NTP server (Windows server 2008r2 192.168.20.5)is running a local clock and according to theory it should serve its owntime to NTP clients right?
Yes. I did check that and set almost the same time as server. I also disabled and re-enabled ntp. Still no luck. Below is the trace of debug message and the result of "show ntp association detail" I did the below steps: router(config)#clock set 23:0...
