Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
First, I have configured over 20+ PIX 501s w/ PPOE with no problems. I am currently working on a PIX 501 6.3.5 trying to get PPOE to work; Keep getting link down/LCP errors. I've swapped cables, dsl modems to no avail.I have another device which conn...
The "Bad Layer 4 Checksum" counter for our IDSM2 (inside 6513) has a very large value. Does anyone have a link/information on this counter ?Thanks,David
I am trying to allow an internal userto access an external PPTP server thruour PIX 6.3(4). I added the needed fixupprotocol "fixup protocol pptp 1723". I am allowing the needed protocols thru and back in (currently testing with allow ip for specific ...
We have had 2 instances in the past 2 months where our 'network' came to a crawl/stop. It is related to our IDSM2 blade in our 6513 via a) Moments before stoppage, could not ping management intf of IDSM2 b) After issuing reset via the 6513by the co...
Does anyone know how to review the details of the "canned" signatures ? Also any reference material and/or links for creating custom ones ?Thanks,David
Which OS ver are you using 4.x or 5.x. I had the same problems with some 4.x sensors. To get them working again (for a short time), had to issue a "hw reset from the switch).One ended up going DOA. I've since been using the new 5.x code, and it seems...
Fixed Problem;1) Removed all references to PPPOE info:vpdn xxxxxxx ,2) Re-Added needed vpdn info , making sure"local name line" was set before authentication line:vpdn group xxxxx ppp authentication pap
Yes, it is possible (that is with PIX xxx on one end). I have a VPN3000 at the main office and PIX 501s at remote sites using "DHCP RELAY". Works greatOne thing you need is a static IP at the remote site.You will need to push that IP back thru the VP...
Thanks for the quick reply. I still have a couple of questions.1) Should I use the command sysopt connection permit-pptp instead ?2) Would this be the only way to get it to work ? Bypassing the normal conduits/ACLS globally seems to be a 'last resort...
It's the serial cable. Are you using the one that came with the VPN 3015 ? I had a time getting the terminal to work. Finally I found the correct cable.Not exactly sure of the pin-outs though.
