Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have problem doing password recovery for my 2503 router. I can connect to the console port via cisco console cable with hyperterminal but after get all the boot-up mesg and load the IOS. I can't type anything but if I can to AUX port, I can type...
Hi,I wonder why my active/standby faiover status have waiting. And when I do sh failover state it failed on Hello not heard from mate at standby state (please see attachment)Failover OnCable status: N/A - LAN-based failover enabledFailover unit Prima...
Hi,I wonder how to exclude certain network from propagate through EIGRP.For example I want to exclude 210.x.x.x network from being advertise through EIGRP but I want local network behind it to be able to propagate through the same EIGRP.Thanks.Regard...
Hi,I need help for this dmvpn implemantation. Before this i'm using vpn site-to-site and it work fine but after I implement dmvpn, the packets start to drops seriously. This is my implementation plans and the configuration of the routers. Could someo...
I have setup a WAN connection between central site to remote site via 4 leased line connection using E1. I have group them up in one multilink interface. But the interface keeps hanging ( not response when ping to remote site) after 3 hours operation...
So, you means the standby ip is for communication only? for example:Pix A(Active)interface Ethernet0 nameif outside ip address 209.165.201.1 255.255.255.224 standby 209.165.201.2 Pix B(Standby)interface Ethernet0 nameif outside ip address 209.165...
I have attach some output and diagram for the network. As you can see from the routerisp3745.txt I want to exclude the routing 210.x.x.x from being advertise by the eigrp but I want the local lan network to be advertise. File which I Attached:1) rout...
