Hi,I would like to know if it is possible to enable or disable the RTS/CTS on a wlan controller; in fact, how to set the RTS/CTS threshold ?Thanks,RegardsGeorges
Hello,I would like to know if it is possible to configure two Vs-S720 inside a unique chassis with SSO redundancy but without the VSL link and the VSS application ?In fact, are we able to use this new supervision card like the Ws-SUP720-3B ?Thanks a ...
Hello,I tried to configure controllers (Wism) to allow multicast traffic (Video) from wired lan source toward wireless PCs. But it doesn't work.Although it works properly on the wired LAN from the same source, when I enable broadcast and multicast (...
Hello,I am going to deploy a guest access with WLC / WCS.In autonomous mode, it is possible to configure "pspf" to avoid that wireless clients perform files exchanges and so on together.Have we the same opportunity in centralized architecture ?I alre...
Hello,I have to configure an AP1242AG to working in a Hot Standby mode. The monitored AP is also an AP1242. However I am not using the Radio A interface so I disabled it but when the monitoring AP check the monitored AP, it detects the Radio A is dow...
Hi Ankur,I have got the outputs of these commands. How can I give them to you ? in a attach file ? Moreover, the "sh ip igmp snooping groups" command does not exist on the cat6k.Regards,Georges.
Hi Ankur,I just done the tests this morning.My Wireless PC has the address 10.0.24.2 and was located to the vlan 12.The multicast address configured on the WiSM is 235.0.0.1How can I give you the files containing the outputs ?Regards.Georges.
Hi Ankur,Thanks for your response.At the moment, I am not able to give you the outputs of the "sh ip igmp snooping group" because I can not have a remote access to my customer's network.Normally I am going to go to my customer tomorrow or the day aft...
Hi Rob,In the monitored AP, the Radio A is shutdown.In the monitoring AP, the Radio A is shutdown too.On the monitoring AP, when I type the command: iapp standby @MAC_Radio_G_of_monitored_AP then the system answers me: incomplete command because it i...