Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have setup a PPTP VPDN on a 1700 router. my internal IP is 192.168.0.0 and I use 10.1.1.0 range for my VPN local pool. is there a way to setup PPtp vpdn (like you do with PIX) where you can assign IP addresses from your internal IP range? I...
Hi all,I have a PIX 525, version 6.3(1) with 2 interfaces active (inside and ouside)I have a single global PAT for sending out and a static entry for my smtp port on a different address.when I sent email the header shows my PAT(ed) IP address as the...
DNS lookups fail on client untill I issuse a command on my 1711 router that triggers a DNS lookup and then the client side works. The 1711 has one default route and firewall is enabled. I am using SDM 2.0 but I had the same problem with 1.1.a also.An...
I understand your point. I don't have different VPDN groups or multiple pools defined. I only want to use an IP range from my intenal IP address space. I tested each configuration seperate and couldn't get the routing to work when my pool was in the ...
Jay, thanks for your reply.I am trying to fix a reverse lookup problem on my domain name that is causing some ISPs to refuse emails from my domain. At the same time I belive I have poor dns confiugration issues that I am trying to fix at the same tim...
