Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking at purchasing the PIX 501 with 10 user licenses. The product manual says:The Cisco PIX 501 Firewall 10-user license supports up to 10 concurrent source IP addresses from your internal network to traverse through the PIX 501. The integra...
I currently have a 3640 router with an analog modem bank. I have six lines that dial into ISPs (using PPP) over these analog lines. I would like to switch the solution to isdn, and I have 3 BRI interfaces. Can I dial with the ISDN lines into the s...
Using the Cisco VPN Client to a 3015 ConcentratorWhen I setup the connection it comes back with "The remote peer does not support the required VPN client protocol." Any thoughts? I have adjusted just about every parameter and still cannot connect ...
I get the following error with my win2k client when going to a 3015 concentrator:22:17:05.005 08/22/01 Sev=Warning/3 DIALER/0xE3300015GI VPN start callback failed "CM_IKE_ESTABLISH_FAIL_NON_UNITY_PEER" (18h).Any ideas? I have followed the setup in...
I have gone through all the vpn config on my 7505, when i go to apply the crypto map on the interface i get the following error:ERROR: Cannot apply IPSEC crypto map with tag MAP_TO_SC8 to VIP interfaces.I have distributed cef enabled and I am baffled...
Each router will need a connection to each switch, and then you will need a tie between the two routers. This will allow you redundancy throughout (I use this setup in my Data Centers). Let me know if you need some more details.
