Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, I have a Cisco C240 M4L. I have 2 internal SSD's using the LSI Software RAID card. I have entered into the configuration utility via Ctrl + M. My 2 drives are listed and I have tried a few times to create a new configuration; however, ever...
Hello All, I have a few errors in my UCS that I believe are caused by some firmware being deleted. I'm getting the following errors: blade-controller image with vendor Cisco Systems Inc, model N20-B6620-2 and version 3.1(1e) is deletedblade-controlle...
Hello All,
I currently have 3 UCS chassis and all blades are currently configured to boot from SAN. this is all currently running perfectly, now I am changing out my san and I need to continue booting from san. Once I move the boot disks over to th...
Hello All,
I have 2 6332 16UP fabric interconnects (FI) with 3 chassis currently configured and operational. I am trying to configure a boot polcy for my C240 M4L. I have the C240 wired and it has checked in to the FI, and I was able to build a pol...
Hello All,
I have 2 6332 -16UP Fabric Interconnects with 3 chassis connected. I am trying to connect a new C240 M4 to my fabric interconnect via a 40gb port. The port has a fault because the chassis/FEX Discovery Global Policy is set to 4 Link. The...
I finally got it work. Even though New Configuration should destroy any configuration you already have this is not what happened. Once I went into view/add configuration I was able to add my drives to a configuration, not sure where the config came f...
That is what I was thinking, thanks for confirming this for me. Can I delete these pieces from the package or should I leave them there? Because they are deprecated and I am not using them I would think it would be ok to delete them, but I don't want...
The 3.1.1 host firmware package is being used in a number of policies. So I know I cannot delete the entire package I was hoping I could delete these two items out of the package without causing issues.
If I click on the highlighted "show policy usage" this is being used. I just am not sure if I delete the highlighted parts here if it will affect the items deployed by the policy linked above.
Ok I will look at scheduling a time to delete these two pieces. I was hoping that because these two pieces were referencing older blade models that I don't have I could just remove them. I'll have to schedule this in case it causes an outage.Thanks,S...
