I am not sure the configuration of PAT overload command. Would someone help me. Thanks. ip nat pool name = lan IP address provided by ISP = 10.10.10.2/24 ip nat outside interface = interface serial 0 ip nat inside interface = E0 (192.168.1.1) ...

I have copied a wrong flash to my router 2612. which causes the router always boot to rommon. How can I boot the router to system instead of rommon. and from where can I download a most updated IOS image for my router 2612 ?? Thanks for your help

Hi, in a cisco ios switch, can I type a command "show spantree" instead of "show spanning-tree" to view configured vlans status. Thanks

Hello, Does it make any difference of: sh spanning-tree summary or sh spantree summary (is this command correct ?) if we want to show stp summary on a Cisco IOS command Thanks

Hi, If I want to start inter-vlan routing on a catalyst 3550. is the following commands enough :3550(config)#ip routing 3550(config)#interface vlan <no> 3550(config-if)#ip address + mask3550(config-if)#no shut Is it still necessary to enable routing...