Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allI have 2 X cisco SDSL routers with no config.I need to setup a SDSL point to point connection.I have a RJ11 cable plugged into both SDSL interfaces - i just need a sample config to continue.Can anyone help me?RegardsMalcolm
Hi allI have a 1800 Router - Connected to a serial WAN Link - this is connected via upstream provider though mpls cloud and is not directly connect to my network.The router also has a DSL backup direct to our network.If any link on the wan goes down ...
Hi I have 2 X cisco 2610 (router A and B)also 1 X cisco 3620 (router C)Router a & b have a 1 MB serial LinkRouter B is main access routerRouter A and C are connected via 2 X wireless links.I need the following RouterB to control Failover. If the 2 wi...
Hi allI am looking to peer with my upstream provider.I am sure that i am going to have to use BGP.I have signed up with afrinic to receive IP addresses and become a local LIR.Here are my questions:1) I have 2 3620 routers with version 11 IOS on them....
It is in the pipeline - however a big version change will require a test environment and this router is in production.I have upgraded from T5 to T7 for now.I hope that makes it a bit more stable...RegardsMalcolm
I was thinking it is either a Software (Update needed) type issue or rather a physical interface problem.I am inclined to think that it is a physical problem as this unit has been working fine for a number of weeks and only in the last week has neede...
I suspect you local machine can not see the cisco Subnet.What is 192.168.1.8 -> can it see the Cisco?Try running a trace route...Also the server that has the ADSL Cisco attached - is it running RRAS ?--M--
