Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Howdy,Have a PIX 525 running v7.0(2) that is reporting the uptime incorrectly from a show version. ASDM reports the correct uptime, however command line shows the PIX as stuck on 49days 17hours.The only reason I noticed was that Cacti is failing to m...
Hello,I have recently upgraded from 6.3(4) to v7.01 and am having some problems with remote VPN connections.In the past we just used the PPTP and Windows XP connection to make a VPN connection.Now with v7.01 I see we have to use Cisco's VPN client, ...
Howdy,Just upgraded to v7.01 on a PIX 525UR. I'm running a Windows domain with two subnets, 10.0.40.0/26 (eth1) and 10.0.50.0/26 (eth2).If I go into Windows Explorer and click on 'My Network Places' I am unable to see any of the other servers. I can ...
Howdy,Can I have more than one outside interface on a PIX?I have two /27 on two totally different subnets. I'd like to be able to route each of these subnets via different interfaces on the PIX.So for example, four interfaces (two public, two private...
I think I found what it was...v7 introduces a new inspect command (fixup on 6.3(4) and below) called inspect NETBIOS.As soon as I removed this from the PIX I was able to see my servers under My Network Places.Still not exactly sure why this occurs th...
I had the same problem when upgrading from 6.3(4) to 7.01.TAC gave me the following to run: conf t ca zeroize rsa ca gen rsa key 1024 ca save allNow those commands are the old commands - when you run them v7 tells you the new commands - I jsut ca...
