Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a ACS box with multiple Windows Group mappings. I have 3 TACACS groups configured for separate networks and a Group set up for Radius authentication. Put simply my problem is that anyone defined in the Tacacs groups can authenticate ove...
Ok, this has been bugging for a bit. At my work we have multiple layer 3 vlans. Vlan 1 is our management vlan and is also a user vlan. For a variety of reasons this bad. My dilemma is that I create a new Vlan for the purpose of management (say vlan 1...
The following interface is having a few problems, as you can see from the errors. The other side of the interface has no errors and its setting for duplex and speed match (not that I can change the speed and duplex anyway on the 100basefx). I do a sh...
Is it appropriate/proper to NAT multiple individual IP's in the following way. If so is there a maximum amount of statements that I can make?example:access-list 101 permit ip host 10.1.1.1 anyaccess-list 102 permit ip host 10.1.1.2 anyaccess-list 103...
could you please tell me where to find the "non-vsa" attribute for DNS. Essentially as you describe it the attribute I am after was "stolen" by Ascend and I can't use that? So this still comes back to my point of how do I assign DNS from the Radius w...
yeah tried setting as ascend and even nortel but it doesn't work for them either. Essentially where the RDBMS is falling over is with the sync. I get a parse error because it doesn't recognise the attribute and that is because I do not know the corre...
This problem stinks. I have tried the RDBMS for IETF 135 and 136 (Primary DNS and Secondary) and it simply doesn't work. I read in places that the solution is ascend but the thing is I need to use framed routes (IETF) aswell. Is this issue a bug in A...
