Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a confusion about HSRP mac address My scenerio is:--I have one access layer switch connected to two distribusion layer switch.for Vlan 2,3,4,5 i am using HSRP now for vlan 2 & 3 dist-sw1 is active and for vlan 4 & 5 dist-sw2 is active.h...
Hi friends,I am confused about Eigrp Metric calculation. If three router's are connected i line like R1====R2====R3 with two link link to eachother.now suppos one of the link between R2 to R3 is 256 k and other links are default to 1544 k. now my qu...
Hi all,I got all the information about eigrp neigbohrship and metric but according to the documentation of cisco router will calculate metric with least bandwidth on the path. So R1 should calculate according to 256 k am i right or wrong pleae correc...
HI All,I am not sure that it is going to work or not but we can this out.Create trunk on all port where host are connected. and where the router is connected. Now your router connected trunk will use the vlan 2 as native VLAN and your host port will ...
HI ,You can try adding permanent keyword after static route because when you enter the static route then router check for next hop ip or interface ip by doing ARP function.but once you add this keyword it will always be there whethere that interface ...
HI addylamlappun,Well this the difference that i got from RFC is The IP Forwarding Table is quite analogous to the older ipRoute Table. The principal differences are:(1) It is somewhat re-organized, for aesthetic reasons,(2) It has the Next Hop ...
Hi all,Well This is about always keyword only.Whenever you use the redistribute or the default-information router configuration command to redistribute routes into an OSPF routing domain, the Cisco IOS software automatically becomes an Autonomous Sys...
