Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Been working to get a 2811 with 4 ADSL cards working, thanks for the help so far.Line 2 is currently connected to a different router so can't se iLine 0, 1 and 3 work on there own.Line 1 works with line 3The big problem now is than when I enab...
Hi All,This has probably been answered some where but I can't find the answer.I have a 2811 with 4 adsl cards fitted and a Ethernet connection to the LAN. I have configured all the ADSL's and they appear to be working.Problem:I can only get 1 link to...
Hi all,I've hit a problem in routing my data.How do i force all traffic comming into S0 (a wic-1t) and out of S1 (a different wic-1t) and vice versa. The cables on both are x21Thanksgnich
Hi AllHope some one can help. I have 2 x 2801's both fitted with a WIC-2AM and running the security IOS. I have configured the VPN using the SDM utility.Problem - no encrypted traffic shown on the monitor but when I run the “Test tunnel†it repor...
Hi,I have a system which uses synchronous modems via a leased line for inter-site connectivity, I need to replace the leased line with a dial up link (no ADSL or ISDN available), but I can not remove one of the modems due to it being integrated into ...
Thanks for the help.It's starting to come together but now the problem has changed.I've got lines 1 and 3 working together (line 2 is in use on the old router) but line 0 has two problems.1 --- Line 0 IP overlaps with line 1 IP, (initially I had been...
OKBeing dumb here,How do i get the nat to use all 4 interfaces as when I try to add another interface egip nat inside source list 1 interface ATM0/3/0.1 overloadit just overwrites the entry as opposed to associating ATM0/3/0.1 with access list 1.TaGr...
