Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Solution to your issue is to use voice translation rule.Use the below link to create one. If you are not able to then reply back. Will help you out.http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a0080325e8e.shtmlRegardsVenk...
Hi rashid,I have a similar MGCP load, however from the phone itself i am able to edit the UDP out/In port number.Once the phone is unlocked,i can browse MGCP CONFIGURATION on the phone where i get the above option to edit. Hope this helps.RegardsVenk...
Hi Ric,Here's the link which will answer your questions.http://www.cisco.com/en/US/customer/products/hw/routers/ps221/prod_configuration_guide09186a008007cf5f.html#wp164538Check the slot.RegardsVenky
Well, with 4 pvdm-12 you can only configure 2 T1's. Basically the dsp is available for only 48 calls. so you have to work out which T1's to use. As far as DSPFARM is concerend,Once we give that command, free dsp's comes into a pool. If we do it first...
