Have a problem, Have a mesh network,Device A and Device B connect into Cisco 7609 to route to other devices on the network.Until recently, they all used E-BGP , and traffic was routed:Device A => Cisco => Network Device B => Cisco => NetworkDevice A ...
A Chairde, My Cisco AS5350 has recently had problems that force us to reload to get services back. When we alter the script, change CODECs , destination patterns , change H323 Voip-ID etc ..., after 3-4 Changes we get this error:1w5d:...
A Chairde, I am having a problem with request mode on my AS5300 , it does not have request mode enabled, I think. Is this enabled by default, or is special configuration needed ??? Have tried using "MODEM PASSTHRU" , but believe this ...
A Chairde, Have a problem , I need to setup (NO)MONITOR SESSION commands for a group of people in my company to allow them to change monitoring ports , I have setup an account and privilege exec , but am having issues getting the global conf...
A Chairde, I am trying to change the H323 port on my Cisco Zone, and have inputted the command :gatekeeper zone local cnibhco111 .*****.*e 192.168.230.129 no shutdownThis works correctly, but if I add .gatekeeper zone local cnibhco111 .****....
Unfortunately, The devices are GUI based, and settings were not changed on Device A, but changed on Device B, E-BGP was switched off , and OSPF was switched on, The OSPF on Cisco is as follows.Relevant IP addresses are:Device A => Cisco 192.168.216.9...
Lads, Just a bit of bumpage , was wonderin, if I have to give people Global access for them to use the MONITOR / NO MONITOR command, do not want them to have access to anything else , if possible ....
Damirs, Thanks for reply, have already ordered 3b , when I checked seen was only larger (should have seen the XL !!!) , but this information adds to my business case. Slan / Ed
