Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks,I ask your help to analyze the following scenario: I have a Cisco 3925 router in my environment. In the interface GigabitEthernet0 / 0 is connected the WAN cable (which is a 100 Mbps circuit. Through this linkI get high traffic Multicast). T...
Dear, I have a question regarding the attached OSPF topology. Here are some details about the topology: * The Neighbor OSPF 1 router can only learn the network route 1* The Neighbor OSPF 2 router can only learn the network route 2* The Neighbor OSPF ...
Hi folks!I have a Cisco Router 3900 in my environment and i would like to monitor its buffer fail events through Syslog Server.In other words, when a buffer fail happen (misses, no memory, failures) the router should generate a Syslog Message to my S...
Hi Folks,
I want to install in my environment 2 devices (1 active and one in standby) that will act as VPN hubs.
I believe that 2 Cisco Routers 2911 will suffice for this.
My questions are:
-What license do I need to apply to get the maximum ...
Hi all,
I got a Cisco ASA 5520 with a VPN Plus license. This firewallIt had a 64MB memory card. I have to switch to a memory cardof 128MB. How do I transfer a license to this new card?
Thanks for listening. Attached are some files. * "Show_commands" files with requested commands; * PNG files showing usage (including Microbursts). The orange line is the average consumption that measured by megabit per second, the red line is the mic...
Thanks a lot JP!
one last doubt: Is there a hardware that offer a better performance than the native hardware encryption acceleration already installed?
