Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,
I am trying to switch from a DS3 circuit to a switched ethernet circuit. We have 2 campuses both with a 3845 router which has a DS3 modules on it. We recently purchased a switched ethernet circuit provided by AT&T. I thought I could ju...
Hi everyone, We have a cisco 4400 series wireless Lan controller with software 4.2.207.0. This controller is been in one of our building and is working for years without any issues. Recently I started noticing that it was responding quite slow but ...
Yes I have to use vlan 1000. I tried tagging like this but this didnt work:
interface GigabitEthernet0/0
description TO SF-MDF
ip address 10.8.6.1 255.255.255.252
shutdown
duplex full
speed 1000
media-type rj45
vlan-id dot1q 1000
exit-vlan-config
...
Hi Jon,
I did not check the arp table. However it was up/up on both side and AT&T could also see the circuits up on their side too. I wasn't able to ping any side.
Ankit
Thanks Gorge. I really appreciate that you took some time out to reply to my issue. We are a college environment and we will be upgrading the wireless soon. Also I restarted the box 4th time. This time I did not turn it back on for 5 mins. Now it see...
