Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Please contact the camera provider to troubleshoot again. Once camera is turn back on, please show ip mroute vrf <VRF name> under both CE & PE routers. Regards,Minh
Hi, If it's allowed to run a debug on router, please try below steps on branch router:In configuration mode:- enable monitor logging at debug level- set logging rate to 1In global mode:- command: debug ip ospf 2 events- command: debug ip ospf 2 packe...
Hi,On both routers, please post the output of the following commands:show ip mroute vrf VPN_user <mcast group>show ip pim vrf VPN_user rp-mappingshow ip pim vrf VPN_user neighbourshow ip pim vrf VPN_user interfaces Also, not sure if it was a typing e...
