Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the following config on Catalyst: logging source-interface Vlan1024 I want to be able to specify an interface vlan as the source-interface on NX-OS. The only option I can get is to use a loopback interface as the source-interface, but I want ...
hi, according to cisco doc that shouldnt happen: Note The write erase command erases the entire startup configuration, except for the following: •Boot variable definitions•The IPv4 configuration on the mgmt0 interface, including the following:–Addre...
