Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Well I have two old Aironet 640-2400 2.4 GHz Ethernet Multiport Wireless Bridges Part Number 200-001797-101B. The question is, can this stuff integrate in any way with the new 801.11b stuff? It is 2 Mb bandwidth, and works fine as a bridge pair. It d...
I have two 340 Series Cisco/Aironet PC cards. When I run the Client Encryption Module on one of the cards it states that "WEP support has not been purchased". I didn't know you could get it without that option. I have upgraded both cards to Firmware ...
Can I use the Radius server that comes on the NT Server options disk with the Aironet access points? I want to enable EAP authentication without spending $6000 for the Cisco secure ACS software. I have used the free NT Radius server with the PIX to a...
Use a Cisco Workgroup Bridge in that building. It looks like a client to the 1200. You may need a directional antenna on the WGB. The WGB only supports 8 devices. If you need more also install a soho router like a linksys and put the PCs on it.Good L...
I have done this succesfully. If you are on a DSL or cable modem sometimes port 80 is blocked by the ISP. Change the port on the AP to 8080 or something other than 80. It should work,
The FCC has put out a statement that it is illeagle to use any amplifier with 802.11 products unless the amplifier and the system have passed the FCC testing as a unit. This is why Linksys can sell an amplifier, and others like Wave Wireless can sell...
I believe everybody who says they will make 802.11g radio chipsets will make them backward compatible to 802.11b. So it should all work together. It will just be slower on 802.11b.Boy won't this be fun. 802.11b, 802.11g, 802.1x and 802.1i all togethe...
