Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So I'm coming across a little bit of a weird issue when entering the "?" command in global configuration mode. Instead of getting the usual single line 2 column description for commands, I'm getting a 2 line 1 column display of commands. Its not brea...
Not very familiar with ASA's at all, so hoping someone can shine some light on an issue we are coming across.
We are experiencing some road blocks in trying to implement a Site to Site VPN connection to Azure. The status of the VPN connection on t...
WLANC - Cisco 5508 series
AP's - 3502i's
In the past there have been test SSID's created that basically mirrored production SSID's using the same VLAN, Flexconnect and Radius information with the exception being security encryption and SSID name. ...
We have several 2702i's that are managed by our 5508 WLC, several users are complaining about slow speeds in general. We tested a couple of AP's in 2.4 and 5ghz only and both cap at around 18-20 mbps up and down. We even forced N connections only but...
The Azure Virtual network is 10.200.0.0 /16
Our On Prem networks would look be 10.0.0.0 /24
Wouldn't NAT take care of any private ip range issues?
Thanks!
I'm not very familiar with looking up information on interesting traffic on the VPN, but in terms of ACL's, as far as we know we matched all the object groups and policy's to the Microsoft specifications provided.
object-group network AzureNetwork...
Update - So it looks like the issue revolved around our ASA not liking the Route Based VPN config that Microsoft gave us. The VPN tunnel is showing up once we did a policy based config... But we can't ping any of the virtual servers that we put up in...
I'm going to touch base with one of our Sysadmins to see if the issues I'm encountering are GPO related or Radius related. But I do have both SSID's on the same VLAN.
8.0.133.0 is the controller software currently on the device.
One SSID is using WPAENT TKIP encryption, while the other is set to use WPA2 AES. Our devices authenticate to the domain using AD Radius servers.
So once a device connects to the SSID...
