Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllI'm trying to configure my Cisco 1131 to act as a DHCP server but the aironet shows 169.24.x.x address for the clients (state = associated). The DHCP scope is configured as per the cisco documentation- 172.16.1.0 255.255.255.0 etc.If i manually...
I changed the BVI interface to 172.16.1.1 (same subnet as the dhcp scope) and it worked.I set the BVI interface default gateway to the fastethernet ip address. i set the fastethernet default gateway to the ISP default gateway but no joy- the clients...
Hi RobinThis is a very open question. presuming you're using cisco products, all concentrators(gui based in design but cli too) support 3des as do most routers/firewalls. A good starting point giving links to VPN enabled products is-http://www.cisc...
hi thereif we're talking about the VPN Group configuration the default is zero (no timeout). the range is 1-65535 before ending the tunnel session. Keep-alive packets and ICMP (ping) traffic do not affect this timeout. This prevents users from usi...
