About c.karl

c.karl · 12-08-2006

Hi guys,I am trying to assign a vlan to the fa 0 - 3 interfaces via dot1x. Im already successfully using this feature on a 6500, a few 2970 and a few 2940. But the 871 seems to be a little different. Im running IOS 12.4(11)T on the 871. When a host i...

c.karl · 11-10-2005

I am trying to configure a cat6500 with two VPNSM and two FWSM in transparent mode with about 30 transparent firewall contexts. The FWSM just works fine, but I cant pass any traffic trought the vpnsm. I am trying to chain both modules. client---vlan ...

c.karl · 09-26-2009

DMVPN is the best solution in your setup. Its quite easy to configure. But you need static ips for the dmvpn hub routers. You could use bgp to advertise the local networks to the hubs, but I would prefer ospf.

c.karl · 12-11-2006

After a reload the config just work. Its always the same. With and without vlan assignment.

c.karl · 11-10-2005

I found the problem. I simply forgot to enable reverse-route injection in the appropriate crypto map:crypto dynamic-map ROADWARRIOR 50 description Remote Access VPN User XAUTH set security-association lifetime seconds 7200 set transform-set SOFTCLIEN...

c.karl · 11-08-2005

I assume that local lan access is not allowed. Depending on the configuration of the easy vpnserver config, you could access the local lan by clicking on the check box "Allow local lan access" in the appropriate vpn profile. If the configuration does...

Member Since	‎06-07-2005 10:36 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6
Total Helpful Votes Received	5

User Statistics

User Activity

dot1x dynamic vlan assignment on a 871

cat6500 msfc2 vpnsm and fwsm problem

Re: VPN between 2 sites with dynamic IP

Re: dot1x dynamic vlan assignment on a 871

Re: cat6500 msfc2 vpnsm and fwsm problem

Re: VPN and local network