Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When building the site to site VPN in FTD/FMC where does the tunnel endpoint exist (what zone)?
For example, in Palo Alto, a tunnel can be placed into it's own zone and the access control policy uses that zone to send traffic to or receive from a r...
I have a 4503-e with WS-X4013+TS supervisor and WS-X4548-GB-RJ45 card. I purchased a WS-X4648-RJ45-E card and installed but IOS says its unsupported. Supervisor is running 12.2(46)SG software and 12.2(31r)SGA firmware. Obviously I'm hoping this ca...
I have a call manager 4.1(2) system connected with a 2811 gateway and T1 with remote users who have VPN connections through internet via ASA (attached with 6MB pipe). The T1 is for PSTN calls. Users who call from remote sites (single users with DSL...
So what you are saying is once the VPN is built using the FMC GUI it's "done?" There's no other configurations, no ACLs to build associated with a tunnel, etc...?What is the purpose, are you aware, of the "tunnel" zone?Andy
Unfortunately there's hundreds of objects too and a hundred Nat rules so it might be worth it to me to get that part of the config imported even if I have to edit or delete 10000 rules.
