Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Linking remote devices to 3750 through 10 meg media converters, remote locations are unable to pass any data ?? I have confirmed this sinario on 2 different 3750's. Any idea's ?? The 3750 replaced a 29XX series that worked with no problems ??
!l2nat instance MainSubinstance-id 1permit allfixup alloutside from host 10.10.91.50 to 192.168.2.5inside from host 192.168.2.2 to 10.10.91.200inter gi1/2l2nat MainSub my computer is 10.10.91.50, my plc is 192.168.2.2, i can ping 10.10.91.200 from my...
config for entire subnet. You might have inside and outside ip addresses reversed.l2nat instance 239instance-id 1fixup allinside from network 10.10.10.0 to 10.200.125.0 mask 255.255.255.0outside from host 10.200.125.254 to 10.10.10.254 gateway There...
Thanks for the insight, never had the opportunity to work with a chassis based switch... Not enough density in my campus... I did open a case with TAC to see what they have to say..
Seems strange that they would include the sdflash port in the switch, complete with a locking mechanism.. It will boot bundle mode @ 785 seconds off sdflash, vs 359 seconds of flash.. Install mode off flash is 205 second boot.
