Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi community,I have 2x SG350X-48MP-K9 V07 and 2x SX350X-12-K9 V03 in hybrid stack, I don't know since when, but I notice that the CPU is always at 100%, I don't have SNMP active, could it be the firmware that is not the latest? now I have 2.5.7.85. T...
Hello, I am newbie, i replaced 2 switches with vlan33 protected by FW with 4 cisco 2x sg350x and 2x SX350X in Hybrid stack. The stack is now accessible from vlan1 and vlan33. Removing FW I have to filter accesses in http https from vlan1 to vlan33. ...
Hello,while I am waiting for my first 4 switches I would like to start practicing, simulating my connections, various configurations, vlan, etc, I can do it, I downloaded "Cisco Packet Tracer" but I can't find my switches. There are other tools that ...
Hello,I am considering purchasing 2 SG350X-48-K9-EU and 2 SX350X-12-K9-EU. i can stack them with FC cables. it's possible ? or I can only use copper. if you have to take the cable with connector or transceivers + fiber cables Thanks
Hello BB,you don't miss the pfsense firewall, it's no longer in the current configuration. firewall managed ONLY accesses in HTTP / HTTPS from 192.168.0.0/24 (VLAN1) to 192.168.33.0 VLAN 33 for device checks and maintenance. The same job now I would ...
i know .. i no longer have pfsense, its work i would like to do at cisco stack. then allow access to the page "https://192.168.0.254/cs4005acaf/mts/config/log_off_page.htm" only some IPs on the LAN (vlan1) and block access to VLAN33 (Management) "htt...
