Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,On three of your routers,you need to configure rip.In rip there are two versions.version 1 will be accepted where vlsm is not used.vr.2 can be used where vlsm is used.hope you wouldn't use vlsm,so rip ver.1 will have to be configured on all the...
Hello Princess,regarding the qus. you have posted,i think you need one router and two switches.Hubs are repeaters and do not switch or route traffic.We can rule them out.You can opt for CAT5 cables.I hope you need to use VLAN technology.
OSPF is a link state routing protocol. We choose OSPF for our networks because it devides the network into areas.When there is an issue at some part of the network,it is confined to only that area.Thats the main advantage OSPF has got.OSPF uses Djiks...
