Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Friends,We have an issue with Sync-status of our Nexus 5596 series switches. Please find the below status. I tried to resync-database, removed the peer destination and tried to import the configuration into the conf sync mode. But yet the sync-...
Hello Friends, We have a WS-C3650-12X48FD L3 Switch, we were experiencing packet discards in the switches on few ports across the organisation, as per Cisco's recommendation we have upgraded the IOS from 16.06.03 to 16.06.05. With 16.06.03 version, p...
Hello Friends,I am trying to add a repository in ISE2 to upgrade the ISE from version 2.2.0.470 to 2.4.I can successfully add the repository adding the host_key in the ISE secondary node. But when I do sh repository SFTP, I see the below error. isese...
Friends, I have 2.2.0.470 version with patch version 8 installed in my ISE boxes, I see lot of options missing under Administration, work centres. for ex: I don't see device administration, and various other options in other tabs, how can I enable t...
Hello Stanti, How can we disable/restrict an interface from sending jumbo frames on to the connected devices? we have a catalyst switch connected to our Nexus 5K, I see lot of jumbo frames being sent on the ports and in the cat switch I see lot of gi...
Hi Giuseppe, We use LACP. in the access switch-> sh etherchannel summary | sec 1Number of channel-groups in use: 1Number of aggregators: 11 Po1(SU) LACP Te1/1/1(P) Te2/1/3(P) --> in the core side sh etherchannel summary | sec 44 Po4(SU) LACP Te1/1/...
Hi Mark,Thank you for your response. No, we don't have router on a stick setup, it's a dist/core C6880 pair with VSS connectivity connecting to number of access switches via port-channel after upgrading the IOS to 16.06.05 from 16.06.03, earlier it w...
Hello Giuseppe, Thank you for your response, we are using C6880 as our core and we are not using any dynamic routing. its just static routing. The switch which I mentioned is an access switch uplinked to the core with port-channel. Thanks!
Thank you Pan and Jason for your insight. I think we should get new smart license for device administration and other stuff. Will get back to you if I need any more info. Regards,Sai.
