Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a base station running the latest firmware (c1200-k9w7-tar.123-4.JA) and a repeater running an older version firmware (c1200-k9w7-tar.123-2.JA2). The Repeater sees the clients but does not pass through the DHCP addresses from the router con...
On the Cisco PoE for a Aironet 1200, the lights labled Power Status and Device Status are blinking opisit of eachother as soon as I plug in the cat5 cable to the device. What does this mean? Is the radio fried? Is there a pinched cable? Please help?B...
I am using a Aironet 1231 with firmware 12.3(4) and I have enabled Multiple BSSID. I have two SSIDs that I am broadcasting that I would like to have guests access. Each SSID has it's own VLAN (1 and 2, 1 being native). When I connect to the first SSI...
We would like to use 802.11a as the backhaul of our wireless systems at certain locations. whe we were configuring the test units, the configuration is almost identical to that of the 802.11G radio. Meaning, that it gives basically to genrall rools, ...
Hi,We have a lot of inventory of cisco 1200s and we are installing them outdoors in NEMA enclosures. Will the cisco 1300 or 1400 workgroup bridges work with the cisco 1200 Access Points?Any help is appreciated.thank you,Jim
Thank you very much! This help out a lot. We are using a HotSpot Gateway with limted Vlan support and are working with the software provider to enable other feature sents that would enable us to have multiple VLANS without inserting a layer 3 switch....
