Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The first thing to do is check the physical layer of the T1. A 'sh controller t1 x/y' should reveal any errors or slips. A reload would clear those stats, so you may not currently have any errors, but I would check the interface anytime you hear st...
Michael,QUESTIONS:1. When the voice quality issues are observed, are the calls from IP phone to IP phone, or, from IP phone to PSTN?2. If connected to the PSTN, what type of connection do you have, PRI or FXO?
Von,I do not have your complete topology, but I would make the following changes:On VG248: Advanced Settings: Passthrough signaling should be set for IOS mode (instead of Legacy)Port Parameters: Caller-ID: Disabled MWI: None Call Super...
When a voice call comes into the router, the router must match dial peers to route the call. For inbound calls from a POTS interface that are being sent over another POTS interface, the router matches a POTS dial peer for the inbound call leg and a P...
