Hi Guys, we have a Catalyst 4003 switch which is a few years old and it's currently running some version of CatOS on it.I have a few questions about this particular switch. I'm going to be playing dumb and asking some probably easy questions, but I'd...

We have the following setup:Pix 500 series firewall running OS 5.3. We have 1 to 1 nat set up. Behind this firewall we have dlink lingo voip gateway.The dlink lingo voip gateway has an external address of 192.168.5.5. We have a one to one nat set up ...

Does anyone have any suggestions for a good hand held t1 tester?Thanks,Brent

We were trying to install a cisco 2650 with a T1 CSU/DSU today and the serial interface would just not come up.The T1 CSU/DSU WIC is a used WIC btw.We started the router up(was never configured). The boot up process displayed all interfaces including...

Let's say I have two networks connected via | |192.168.0.0/24|---------|192.168.1.0/24 | |Both are able to reach each other via simple static routes. What configuration should I set in each router config in ...