Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I just finished my MPLS configuration but I have one last roadblock. I can reach my HQ LAN(10.10.1.0/24) from my branch but HQ cannot reach branch LAN(10.10.3.0/24).This happened after I did NAT outside and NAT inside on the branch rou...
Hi Everyone,I need your help with this configuration. The same configuration one my other with on a different branch but these configs are not working on my other branch.I can reach the interface 10.10.1.1 and go to the internet without access-lists,...
Hi everyone,You'll have to forgive me.My configs worked on my first router on the first branch but on my second branch router, things are not going as planned.I can receive internet from my firewall at 10.10.1.1 to my branch LAN on 10.10.3.0/24 but I...
Hi everyone.I have a problem I cannot understand.On a Cisco 891 I have made Port FE8 the WAN port with ip add - 192.168.124.10.I have created VLAN 10 - ip add 10.10.3.3 for the LAN ports FE 0 - FE5(Access mode)The problem is, a PC on the LAN 10.10.3....
Hi Everyone, I always get help from this forum so I am confident an solution will be found here.I have this Cisco Router 891I have put IP addresses on gig0 - 192.168.124.10 and FE8 - 10.10.3.3,I can ping FE 8 but not Gig0. Do not know why. Maybe you...
Hi @Leo Laohoo ,thanks for the suggestion. Fortunately, it's real life, the image is just a network map.@Georg Pauwen , it is not a packet tracer project. I just used PT to draw my network map. the issue is on the router configurations.
Hi @paul driver @RicardoSN @Giuseppe Larosa , Thank you for your responses.We discovered that the problem was with the ISP. They had no advertised the routers to my LAN.
