About Techworking

Techworking · 05-17-2021

I have a multihomed scenario with two routers connected to two different ISP's.The inside interfaces of the routers have VRRP configured and are both connected to the same switch.IP SLA reachability is set up to track reachability to 8.8.8.8 in the ...

Techworking · 12-12-2019

I have a Cisco 4331 router directly connected to an ISP router switch port.Layer 2 is fine as I can see the mac address of the ISP router in the arp table.There are no filters on the 4331 i directly connected interfaceHowever at layer 3 pings are fai...

Techworking · 05-18-2021

Hi Balaji,Yes the trigger has been met.When the interface went down, the internet became unreachable.If it was working correctly the ICMP probes would have triggered.However as said earlier I am not seeing any ICMP packets being sent out by IP SLA 10...

Techworking · 05-17-2021

There was another object that was being tracked but has been removed

Techworking · 12-12-2019

Hello GeorgePinging default gatewayUnknown drops do not correspond with pings

Techworking · 12-12-2019

sh int gi0/0/0 switchport% Gi0/0/0 is not a switchable portsh run int gi0/0/0interface GigabitEthernet0/0/0descriptionip address x.x.x.x 255.255.255.248no ip redirectsno ip unreachablesno ip proxy-arpload-interval 30media-type rj45negotiation autoend...

Member Since	‎06-28-2018 06:37 AM
Date Last Visited	‎08-18-2021 12:04 AM
Posts	6

User Statistics

User Activity

VRRP and IP SLA Reachability Issue

Ping fail between Cisco 4331 and ISP Router

Re: VRRP and IP SLA Reachability Issue

Re: VRRP and IP SLA Reachability Issue

Re: Ping fail between Cisco 4331 and ISP Router

Re: Ping fail between Cisco 4331 and ISP Router