Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We can get to EXEC mode on our console ports when TACACS is running, but can't go to PRIV mode. Disconnecting TACACS permits full access through the console. I know we're missing something simple, but can't find it. Please help.
User has a Windows Load Balancing Server with 2 nodes setup in a server farm. We recently changed out the 5500 with a 4506 with multiple vlans. The 5500 was running vlan 1 only (spanning tree was enabled) and the setup worked. His pings from one node...
Can't seem to clear standby group information from an interface I've changed in a 4506 router with a Sup IV module. IOS ver is 12.1.Interface was configured for standby group 2. We mistakenly applied standby group 5, which was already assigned to v...
I'd like to permit a portion of a Class B subnet for snmp access. The subnet's mask on the router is 255.255.255.0 and I'd like to permit the 208 ip and fifteen IPs after it.set ip permit ###.###.###.208 255.255.255.15 snmpwhen viewing the permit lis...
I do have level 15 access becuase I'm at the PRIV prompt when logging in using vty. The TACAS admin indicated that my 15 is set due to the domain used for authentication. Other users get the USER EXEC prompt and aren't permitted PRIV mode. This fu...
"When entering the enable command when TACACS is working you would normally enter the users TACACS password again to get into privilege mode."Exactly, but it's not working. There must be something in TACACS disabling privilege mode from the console ...
Thanks again for your quick response Rick.The TACACS account for "temp000" (not the real UserID) is set to put me in PRIV mode automatically. I can't type enable because I'm already there.I'm using my domain password when logging using "temp000". I...
I enabled debug and am submitting this attachment of the output. The problem area is in the "Enable mode attempt via console using temp000" portion of the attachment.Let me know if you see anything useful and thanks again.
