Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Olá PessoalEstou tentando configurar um PPPoE server no IOS XR 9010, por enquanto sem sucessoTenho um IOS XE no ASR 1002 rodando normalmente como BRASMas to com dificuldade no IOS XR,Não funcionou nada até agora, nem log de pppPenso que pode ser algo...
I have a VXR7206 NPE-G2 router running as a PPPoE server. My lan network is 172.16.99.0/24, and after creating access-list 1, I lost the ability to ping the lan network from outside the Router. I only have this acces-list, and when I delete it the pi...
Hi all,
I'm configuring AR10002f as BRAS pppoe server but it has been rebooted and apparently it's because of some process in the Virtual-Template, if anyone can help me figure out the cause of the crash I roared so grateful.
ASR1000-EXT-SIGNAL: ...
Hello After trying to upgrade from 512 to 623 RSP440-SE, the RSP no longer loads. After the upgrade she restarted 3 or 4 times and then went into a romom. I tried uploading a .vm file via tftp, but it also didn't work. The error is always the same:ro...
Hello guysI have followed this forum in several situations and have found many answersMy question however is about hardwareI have a 9010 with RSP-440-SE with A9K-MOD80-SEAnd it runs BGN Services wellI have another 9010 that I am putting into operatio...
Using A9K-RSP440-TR and A9K-MOD80-SE, its possible config PPPoE SERVER? Version disk0: asr9k-bng-px-6.5.3 ASR 9010Nothing yet...#dynamic-templatetype ppp PPP_TEMPLATEppp authentication chapppp ipcp dns 8.8.8.8ppp ipcp peer-address pool POOLv4ipv4 u...