Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day.I can’t configure Sonos via WIFI network. Built on CIsco WLC 2504.Attachment Scheme.When setting up, you need to press the buttons on Sonos and it starts sending broadcast pacet to the network at the address 255.255.255.255. which the phone ...
Thank you all for your help. The problem is resolved.The decision was trivial. The management interface of the WLC controller did not have L3 connectivity with the interface Dynamic AP Management to which the points were connected. It seems that all ...
Thanks for the help.I tried using a different multicast address, this did not help.I am using the cisco switch. IGMP snooping is enabled by default on them.
Controller -> mDNS -> General -> Global snooping checked.Controller -> General -> Broadcast Forwarding enabled.Controller -> General -> AP multicast mode set to multicast with the ip 239.255.255.250.Yes, I made all these settings.I have attached a sc...
Yes SONOS used Multicast, but to install a new device, he requires a broadcast on 255.255.255.255. This is not very good and can only be installed from a mobile phone. I send request support sonos.SONOS connect to lan but controller installed on a mo...
