Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have used it before, but I prefer to just do it by hand. It's a good start though.I would take the cat config line-by-line and configure the correct IOS command for each.Use the utility though, it's a good start, but make sure you double check bet...
Easy fix. Insert a TAP between the switch-span and the monitoring device.switchspan--------olddeviceusing TAPswitchspan --------TAP -------olddeviceThe TAP gives you a 3rd interface that you can plug into the new device. This way you don't have to ...
Monitor it with SNMP. See if there are any interface errors relating to something connected to it. Check utilizations (cpu/interface/over subscription)If you think it's traffic related based on SNMP stats, you can alway turn on netflow to find the ...
If I remember right, the "network neighborhood" is NETBIOS based which uses broadcasts. Try using a WINS server. I honestly haven't used the network neighborhood for sometime now.When accessing other pc's by name, try using:\\machinename.domain.xyz...
