Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are getting an UPDOWN message for the FastEthernet interface of a 3745. The message is issued every 10 minutes (exactly) and indicates the interface is UP. We never see the interface go down. I have done all the obvious things like change the cabl...
I have a PIX 515E running PIX 6.3(4) connected to the internet using PPPOE. The IP address for the outside interface is set using the command:ip address outside pppoe setrouteHowever, sometimes after the connection fails (happens a lot here), I get t...
I have a 3005 concentrator used for WebVPN remote access. I am authenticating the logons using a Microsoft IAS server. It apppears that WebVPN is authenticating with PAP and I am concerned that this is not secure. Does the 3005 support authentication...
Cause of problem discoveredI have finally discovered the cause of this problem, if not a solution - but not before it brought the Fast Ethernet interface down during prime shift. Anyway the culprit was a rougue server running IBM Director. This serve...
I intend to try using FastEthernet f0/1 tomorrow when I can make the change without impacting users. My thinking is also that this may be a hardware problem.Here is the output from show ver:Cisco Internetwork Operating System SoftwareIOS (tm) 3700 So...
Thanks, I understand what the message means. My problem is that I have to manually delete the old route set by the setroute option before the link comes back. This can result in the link being down for hours until I can get in to make the change. Thi...
