Can you please assist in confirming if we can position a Cisco ISE solution to our customer.We have been exploring HPE ClearPass with them for some time but have come up against a number of issues around what they are looking to achieve.I am not 100%...
Having an issue with 2 BR350 wireless bridges. The two units infrequently give the following report, Disassociating Sender is Leaving (has left) the BSS"And the link is disassociated.Any idea why this occurs? Firmware bug? Radio problems, the link sh...
I have a customer with a CSS11503 chassis and a Milan 1000T to 1000SX MMF SC media converter, MIL-C6113SX attached into the copper gig ports.They get a link light on the media converter for the copper interface but cannot poll the switch.Is there any...
When using the Bridge Outdoor Calculation Utility from Cisco i notice the cable drop down menu only includes the old STD type cables. Now Cisco have EOL'd the STD and 75ft cable, replaced with the LL cables, AIR-CABxxxLL-R products how does the calcu...
I have a few AP1200's which have the WEP keys and User Manager names set, therefore i cannot connect wirelessly. I have tried connecting over console and see the unit boot up, however when i try to enter Setup> Security page it prompts me for a Usern...
Thank you very much Viktor, very much appreciated. We also had the following content from:Cisco Partner Plus Global Virtual EngineeringI'm looking to other options but using ISE 2.2 import the MAC addresses of the Linux boxes for example and essentia...
I have seen similar issues with bridge links i have set up, even in lab scenarios with the bridges 2 metres apart. I have this error on 11.23T firmware, i downgraded all units to 11.10T1 and all is good now. Maybe try that.First try an Antenna Allign...
The 4800 firmware is available here:http://www.cisco.com/pcgi-bin/tablebuild.pl/aironet_4800_series_apIt seems you have a later release than they have posted so i would recommend sticking with what you have. It is unlikely there will be any more firm...
Cisco's data sheet on the AP350 states:The Cisco Aironet 350 Series AP is available in a rugged version (AIR-AP352E2R-x-K9). This enhanced version includes two RP-TNC connectors for use with optional antennas, an extended operating temperature range ...
You may have WEP enabled on the AP but NOT on the PCM Card?Also, if the card is a PCM340 it has no WEP support, if it is PCM341 it only has 40 bit WEP functionality, if it is PCM342 it has 128 bit WEP support and should be OK.Check you WEP key settin...
