Access Point Configuration Question:If you've never used the browser to configure your AP, then I suspect that you are using a different model than the one that I assumed. I had assumed AIR-AP340, but it could be a different 340 product like a bridg...
1. Actually you don't have to worry about the "Ethernet Encapsulation Transform" setting on your client. This setting is only in the access point. You can find it by browsing to the Setup page and then look in the bottom-right corner of the screen...
These instructions assume that you are starting from factory defaults.STEP 1: Select madatory WEP encryption and set a 128-bit key in encryption key 1. Your clients will need to match this information. They will need a 128-bit key in the same slot...
Broadcast key rotation can only be used with authentication methods that allow for dynamic keys. In other words, if you are using some kind of EAP-based authentication, you should be able to use BKR.When you are using static WEP, then BKR cannot be ...
The debug message you referenced is an indication that the client is not responding. In my experience, if the client doesn't respond in 30 seconds, it probably isn't going to respond at all. The only exception that I've seen is when the client is w...