i have multiple E1 links. i need to load balance but this platform supports only per destination which does not fullfill the requirement. The voice is running on this network. If anyone has any idea do share. NOTE: NO MLPPPRegardsJB
HelloI have installed v.35 card (PA-8T-V35) with octal cable. The problem is this that i cannot see 'show controller' information for serial ports. 'show contrller' support only this:Router#show controllers ? E1 E1 controller internal state T...
Actullay there are multiple(8) point to point links between 7606's. In the peak times, one of the links are choked (95%) while other links are less utlized (60%). This cause the problem for voice calls which are on choked link and some time is not po...
what is service policy on the serial interface? secondly you should define the configuration on MLPPP bundle instead of idvidual link. Here is example which i am using:interface Multilink7 description Multilink ip address 10.10.11.13 255.255.255.252...