Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok I have just moved companies and found an ISE 2.2 installation that to be honest is a mess - someone migrated from acs to ise without cleaning up the data first, so the rules are “interesting”, as if the fact that we don’t have the encryption key f...
Ok, thanks to both of you for the suggestions, as you say purging the m&t data seems to make the most sense. However going back to the release notes it states: Restore MnT BackupWith the operational data backup of MnT data that you created before upd...
Couple of questions to help you1 what does the ise console say2 what is the port config set to and the radius auth commands.As you say if it is authenticating then it should show up but there isn’t much to go on here.
Check the layer 2 topography and run show spanning tree summary. If you run this from the edge switch ensure it is not the root switch, then run show spanning tree vlan xxx.Check the right ports are trunking the vlan up and post the results back here...
There are two settings you need. (Based on the 9630 series phones). The data scope needs dhcp option 242 set to L2Q=1,L2Qvlan=(voice network). The phone will read these parameters and then reboot itself to and place this it in the voice vlan. On the...
