Hi Makgive this command on the serial interface which is connected to the ISPaccess-list 110 deny icmp any anyaccess-list 110 permit ip any anyOn the interface-------ip access-group 110 outHope this will serve yur requirementregardsPrashant

Hi,THERE IS ONE cRITERIA u should keep in mind when giving lopback address in large Network when yu are using OSPF ,Yu have to check in the Requirement of higest IP address ,Because the highest IP address becames the DRRegards

Hi spremkumar,if yu wanna do load balancing on lease line and ADSL, try doing Policy based routing for load balancingRegardsPrashant J sansare

Hi BinoyI hope there are 2 Power supply in the 6000 Series Switch is the Redunandant power supply on.... and functioning properly....RegardsPrashant J Sansare.

Hiwht yu can do is on your Lease line serial Interface configure the isdn has a backup interface by giving command example :1)backup interface bri 02)backup delay 20 60after giving this command yur isdn interface will be in standby mode once lease li...